GlobalLink 520 or a Cerbo GX with GX LTE 4G for remote RV monitoring?

Answered by RV Parts Giant · Upland, CA · October 24, 2026

Short answer: GlobalLink 520 if you only want to check the battery, solar and charger from home every 15 minutes. It has a built-in SIM and draws 20 to 50 mA at 12 V, but it can't change settings or run a Remote Console. Choose a Cerbo GX with a GX LTE 4G-A if you need near-live data, remote control and settings, or wired VE.Bus.

Both get your rig onto VRM over cellular. They're built for different jobs, and Victron's GlobalLink FAQ says plainly that you can't use the two together. The GlobalLink takes the place of a GX device. It doesn't plug into one.

What the GlobalLink 520 does and doesn't do

  • Reads: up to two VE.Direct devices by cable, such as an MPPT, SmartShunt/BMV, Orion XS or Smart IP43 charger, plus up to ten Bluetooth Victron devices through Instant Readout. That covers SmartSolar, SmartShunt, Smart Battery Sense, Lithium SuperPack NG, the NG BMSes and a MultiPlus through a VE.Bus Smart Dongle. RuuviTag sensors work too.
  • Sends: a snapshot every 15 minutes. Victron's FAQ says it doesn't store data to send later, so a dead zone leaves a gap in the history.
  • Can't: change a setting, update firmware, switch an MPPT load output or open a Remote Console. It also has no GPS and no Wi-Fi. The one remote action is its own relay, which you can switch from VRM.
  • Draw at 12 V: 50 mA with Bluetooth on, 20 mA with it off, and more with the relay closed. That's about 0.5 to 1.2 Ah a day, small enough to leave on during months in storage.

What a Cerbo GX with GX LTE 4G adds

  • Takes the place of the app on the road. It shows live data, and the Remote Console through VRM lets you change system settings from home, and Victron's GX manual says firmware updates can be done remotely too. Victron says that needs two or three bars of signal.
  • Wired VE.Bus for the MultiPlus/Quattro, VE.Can, tank and temperature inputs, relays, and coordinated charging (DVCC).
  • Costs more power. The GX LTE alone draws 2.5 W while sending and under 1 W at idle, and the Cerbo adds its own draw on top.

The decision rule

  • Stored trailer, or a simple MPPT plus SmartShunt system, and all you want to know is "is the battery OK?" Get the GlobalLink 520. It has its own five-year SIM and needs no setup.
  • You live in the rig, run a MultiPlus, or want to fix settings remotely. Get a Cerbo GX plus a GX LTE 4G-A (the North America model), or put the Cerbo on the rig's Wi-Fi router.
  • You already own a Cerbo. Don't add a GlobalLink. Give the Cerbo an internet connection instead.

What you need

Want the full walkthrough? Read the complete guide.

Have a different question? Tell us your rig and what you're trying to do. Ask an expert