Sterling Pro Split-R isolator or split charge diode: which one for my alternator?

Answered by RV Parts Giant · Upland, CA · November 13, 2026

Short answer: Pro Split-R if your house bank is undercharging: it switches with almost no voltage drop, while even Sterling's diodes lose about 0.74 to 0.78V. Size either one to your alternator's rated output and pick 2 or 3 outputs. Sterling says the Pro Split-R is not for vehicles with an advanced ECU; use a battery-to-battery charger there.

Both let one alternator charge two or three batteries (engine, house, and perhaps a second house or thruster bank) without a heavy house load pulling current back out of the engine battery. The difference is how much voltage they cost you on the way.

Voltage loss, the deciding number

  • Split charge diodes (D-series): Sterling says its diodes drop about 0.74 to 0.78V, against 0.93 to 1.1V for conventional diodes in its 30 to 70A test. Less loss than most, but still most of a volt. Sterling pairs them with an advanced alternator regulator to make up the drop.
  • Pro Split-R (PSR): microprocessor-controlled switching with almost no drop. It also briefly isolates a full engine battery so the alternator regulator only sees the empty house bank and charges it harder, disconnects the alternator if its own regulator fails, and fails safe with the engine battery still connected.

Sterling's own copy says a diode's loss leaves house batteries undercharged, and raising the alternator voltage to compensate can overcharge the starter battery. If that is your symptom, the PSR is the fix; a diode suits a simple setup that already has a compensating regulator.

Sizing: match the alternator

Both ranges are rated by maximum alternator output. Pick the rating at or above your alternator's label.

12V alternator Pro Split-R 2-bank / 3-bank Diode 2-bank / 3-bank
up to 70A — — / D70A3
up to 90A — D90A2 / D90A3
up to 120A PSR122 / PSR123 —
up to 130A — D130A2 / D130A3
up to 160A — D160A2 / D160A3
up to 180A PSR182 / PSR183 —
up to 200A — — / D200A3
up to 250A — / PSR253 —

Sterling builds in margin: it rates the 180A PSR for 240A continuous. 24V Pro Split-R units (60, 100, 150 and 240A) are also stocked.

2 or 3 outputs: count the batteries, engine included. Engine plus one house bank is 2.

When neither is right

Sterling states the Pro Split-R is not suitable for modern European vehicles or anything with an advanced ECU, and says to use a battery-to-battery charger there. If your van or chassis has an advanced engine computer, that applies to you. For lithium house banks, Sterling's lithium advice in our listings also points to its battery-to-battery chargers.

Not sure of your alternator output? Send us the vehicle details. Shipped from Upland, California.

What you need

Want the full walkthrough? Read the complete guide.

Have a different question? Tell us your rig and what you're trying to do. Ask an expert