Do I need the Victron BMV-700H for a 48V battery bank?

Answered by RV Parts Giant · Upland, CA · November 20, 2026

Short answer: No. The BMV-700H needs a 60 to 385V DC supply, so it is built for high-voltage battery systems. A 12V, 24V or 48V (51.2V) RV bank sits inside the 6.5 to 70V range of the BMV-712 Smart and the SmartShunt, and both of those have Bluetooth built in, which the 700H does not.

The "H" is the part people misread. It does not mean heavy duty or higher current. It means the monitor runs on a high-voltage supply, and that rules it out for almost every RV bank.

The one number that decides it

The monitor takes its power from the bank it is measuring, through the positive lead (a 1.5 m cable with a 1A fuse on the 700H). So the bank voltage has to sit inside the monitor's supply range at all times:

Monitor Supply range Fits a 12V bank 24V bank 48V (51.2V) bank
BMV-700H 60–385V DC No No No
BMV-712 Smart 6.5–70V DC Yes Yes Yes
SmartShunt 6.5–70V DC Yes Yes Yes

A 51.2V LiFePO4 bank stays under 60V even on charge: our 48V lithium chargers charge at 57.6V. That puts it below the 700H's minimum and well inside the 70V ceiling of the BMV-712 and SmartShunt. In practice the 700H is the monitor for a pack that always runs above 60V. If you are not sure which you have, read the nominal voltage off the battery label before ordering.

What you get with the 700H, if you do have a high-voltage pack

From the Victron listing (part number BAM010700100):

  • Shunt included: 500A / 50mV with M10 shunt terminals.
  • Display: 63 mm round head, 69 x 69 mm bezel, flush mount, IP55, so indoors only.
  • Alarms and relay: audible and visual alarms, plus a normally open relay rated 60V / 1A. That relay is a signal contact. On a pack above 60V, use it to drive a separate relay or contactor coil, not to switch pack voltage directly.
  • Data: 46 days of history, 0.4% current accuracy, capacity settings from 1 to 9,999Ah, 4 mA draw.
  • Connectivity: a VE.Direct port but no Bluetooth. Add a VE.Direct Bluetooth Smart dongle for VictronConnect, or a VE.Direct cable (not included) for a GX device.

For a 12V, 24V or 48V RV bank

Choose between the BMV-712 Smart (display head, alarm, relay, Bluetooth) and the SmartShunt (no display, reads in the app or on a GX screen). The parent guide covers that choice. Either one also has the auxiliary input the 700H lacks, for a starter battery voltage, a midpoint reading or a temperature sensor.

Not sure which voltage or shunt size fits your build? Send us the battery label and your largest inverter or charger and we will tell you which monitor matches.

What you need

Want the full walkthrough? Read the complete guide.

Have a different question? Tell us your rig and what you're trying to do. Ask an expert