Which connector do I need for a Victron Blue Smart IP65 charger: eyelets, clamps, plug or MagCode?

Answered by RV Parts Giant · Upland, CA · October 27, 2026

Short answer: The charger already ships with a ring-terminal lead and clamps, so you only buy a connector to change how it attaches. Fused M6/M8 eyelets (30A) are the leave-on-the-battery option, the clamp lead (30A) is for the workshop, the cigarette plug (16A fuse) and the MagCode clip and port (15A at 12V) suit chargers up to 15A, and none of those three is for the 12/25 or the 24V models.

Every Blue Smart IP65 we sell comes with a 5 ft DC lead ending in M8 ring terminals plus a set of clamps, all on the charger's DC connector. The accessories exist so you can swap that lead for a connection that suits how you charge. Pick by the charger's amp rating first, then by convenience.

The options

Accessory Fuse / rating Best for
M6 or M8 eyelet lead 30A ATO fuse Left bolted to the battery; the charger plugs on and off at the DC connector
Clamp lead 30A ATO fuse Moving between batteries, loaner batteries, the workshop
12V cigarette plug 16A fuse Topping up through an accessory socket without opening a battery bay
MagCode Power Port + Power Clip 12V, 15A max A fixed magnetic inlet on the vehicle; the clip snaps on and releases cleanly
2 m extension n/a When the charger has to sit farther from the battery than the standard lead reaches
Battery indicator eyelet or panel 30A ATO, M8 A state-of-charge LED that stays on the battery between charges; 12V lead-acid only, 0.9 mA drain

Match the connector to the charger

The IP65 range runs 6V/12V-1.1, 12/5, 12/7, 12/10, 12/15, 12/25, 24/5, 24/8 and 24/13. The second number is the charge current, and two of the accessories cannot carry all of it:

  • 12/25: the 16A plug fuse and the 15A MagCode rating are both below 25A. Use the eyelet or clamp lead, which are fused at 30A.
  • 12/15: the MagCode's 15A ceiling is exactly the charger's output. The cigarette plug's 16A fuse clears it, but the vehicle's own socket fuse is usually smaller; check it before relying on that route.
  • 24/5, 24/8 and 24/13: the plug and the MagCode parts are 12V accessories. Stay with the eyelet or clamp leads.
  • 12/5, 12/7 and 12/10: any of the options works.

Choosing between eyelet and MagCode on an RV

Both leave a permanent fitting on the vehicle. The eyelet lead is the cheaper one and hides inside the battery compartment, with the DC connector dangling where you can reach it. The MagCode port mounts through a panel so the charger connects from outside without opening anything, and the magnetic coupling is the point if the same charger serves a coach, a tow vehicle and a boat. If you need the indicator panel as well, it is a separate M8 eyelet with its own 39 x 22 mm cut-out and 1.5 m of AWG12 cable.

Whichever lead you choose, keep the inline fuse. It protects the lead, not the charger, and the charger has its own reverse-polarity and short-circuit protection.

Blue Smart IP65 chargers and all of these accessories ship from our Upland, California warehouse.

What you need

Want the full walkthrough? Read the complete guide.

Have a different question? Tell us your rig and what you're trying to do. Ask an expert