Which Victron MPPT solar chargers take the SmartSolar pluggable display?

Answered by RV Parts Giant · Upland, CA · October 24, 2026

Short answer: Only the larger 150 V and 250 V controllers with a "display option" cover on the front: SmartSolar 150/45 to 250/100, and SmartSolar or BlueSolar 150/70 to 250/100 VE.Can. The 75 V and 100 V SmartSolar models common in RVs have no display port. For those, fit the MPPT Control on the VE.Direct port.

The SmartSolar Control display (SCC900650010) doesn't connect with a cable. It plugs straight into a 9-pin port on the front of the charger. Only some controllers have that port. Victron's manual lists them:

  • SmartSolar MPPT 150/45 up to 250/100
  • SmartSolar MPPT 150/70 up to 250/100 VE.Can
  • BlueSolar MPPT 150/70 up to 250/100 VE.Can

The 10-second check

Look at the front of your controller. If there's a small plastic cover printed "display option" held on by two screws, the display fits. If there's no cover, it won't. That includes the 75/10 through 100/50 SmartSolar controllers most vans and trailers use. For those, the wired panel is the MPPT Control, which connects to the VE.Direct port with a VE.Direct cable.

Fitting it

  1. Remove the two screws and the "display option" cover. Keep the screws.
  2. Pull out the two small plastic plugs on either side of the connector.
  3. Peel the backing off the double-sided tape, push the display fully onto the connector, and screw it down with the original screws.

It's hot-swappable, so you can plug it in or pull it with the charger running. For a temporary check, you can skip the tape and screws, use it, and take it to the next controller.

What it shows and changes

Live battery voltage, charge current and stage, PV power, voltage and current, charger and battery temperature, load output state on models with a load output, plus 30 days of history and lifetime totals. You can also change charger settings from it, unless the setup menu has been locked.

Pluggable display or MPPT Control on a 150 V controller?

The pluggable display covers one controller and sits on its face, so it suits a charger mounted where you can see it. If the controller is hidden in a bay, use the MPPT Control in a wall enclosure where you can see it, or a Cerbo GX for the whole system.

What you need

Want the full walkthrough? Read the complete guide.

Have a different question? Tell us your rig and what you're trying to do. Ask an expert