Victron Lynx Smart BMS: do I need the NG or pre-NG, 500A or 1000A?

Answered by RV Parts Giant · Upland, CA · November 19, 2026

Short answer: Read your battery label: Victron Lithium NG batteries need the Lynx Smart BMS NG, and the older Lithium Smart batteries need the pre-NG BMS. Then pick 500A or 1000A by your biggest current: at 12V, 500A is about a 5,500W inverter load. The M8 pre-NG unit will not join an M10 Lynx Distributor.

There are three choices on the listing, and the battery decides the first one for you.

1. NG or pre-NG: match the battery

Your Victron battery BMS to order
Lithium NG Lynx Smart BMS NG (500A or 1000A, M10)
Lithium Smart (earlier generation) Lynx Smart BMS pre-NG (500A M8, 500A M10 or 1000A M10)

The two do not cross over. The model is printed on the battery label, so check it before ordering, especially on a used bank or a rig you bought with the batteries already fitted.

The NG version also adds a built-in contactor, a pre-charge circuit for inverter inrush, a battery monitor, Bluetooth, VE.Can, and an alternator mode that cuts the alternator before the battery.

2. 500A or 1000A: size by your largest current

The BMS sits in the main battery path, so its rating has to cover the biggest current the system draws or charges at. For an inverter, divide watts by 11.04 (12V at 92% inverter efficiency):

Inverter at 12V DC current BMS
3,000W about 272A 500A
5,000W about 453A 500A, close to its limit
2 x 3,000W about 543A 1000A

At 24V the same inverter draws half the current, so a 24V system rarely needs the 1000A.

3. M8 or M10 studs

Only the 500A pre-NG comes in M8; every other version is M10. That matters because the Lynx modules bolt together, and the Lynx Distributor we stock is the M10 version (LYN060102010). Victron's listing for it says M10 and M8 modules cannot be joined. If you are adding Distributors, take an M10 BMS. If you already have an M8 Lynx line, ask us before ordering.

What else to plan for

The BMS is the hub, not the whole system: battery and load fuses go in M10 Lynx Distributors, and the BMS can monitor up to four of them. Part numbers: LYN034160310 (500 NG), LYN034170310 (1000 NG), LYN034160200 (500 pre-NG M8), LYN034160210 (500 pre-NG M10), LYN034170210 (1000 pre-NG M10).

What you need

Want the full walkthrough? Read the complete guide.

Have a different question? Tell us your rig and what you're trying to do. Ask an expert