Does a LiTime battery need a new charger or converter in my RV?
Usually the charging source needs a lithium profile. LiTime recommends a 14.6V charger sized to the battery: 20A for its 100Ah Group 24 and Group 2...
Usually the charging source needs a lithium profile. LiTime recommends a 14.6V charger sized to the battery: 20A for its 100Ah Group 24 and Group 2...
Yes. LiTime rates its 12V house batteries for up to four in parallel and four in series (4P4S), using identical batteries. The 24V 100Ah models all...
No. LiTime states the 48V (51.2V) 100Ah ComFlex needs no shunt in a Victron system: it reports 25+ battery data points to the Victron display, VRM ...
It can, if you set it to its 20A mode. The LiTime 12V 40A DC-DC charger has selectable 20A or 40A output, and a factory 7-pin charge line is not bu...
Yes. LiTime rates the 12V 320Ah Mini at 2,560W continuous from a 200A BMS, with up to 1,000A peak, so a 2,000W 12V inverter is inside its limit. Si...
LiTime builds its 24V 100Ah batteries for exactly this: each stores 2,560Wh, equal to two 12V 100Ah batteries, and LiTime markets them for truck pa...
LiTime's guide for its 12V 100Ah TM Bluetooth battery is one battery for a 30 to 70 lb thrust motor, two for 70 to 100 lb and three for 100 to 120 ...
The Lynx Shunt VE.Can holds the system's main fuse as a CNN fuse. Victron stocks the 325 A / 80 V CNN (CIP140325000), but its manual says any CNN f...
A hub is matched by five things: axle rating, bolt pattern, stud size, the bearing races pressed into it, and whether the front is threaded for a s...
On an 8,000 lb axle with 8 on 6.5" hubs, DeeMaxx and Dexter list a 25580 inner bearing in a 25520 race and an 02475 outer bearing in an 02420 race,...